[Sax-project-users] Sax-1.0.1

[marsamos at democritos.it]

The static epsilon of example 2 is just the static vacuum epsilon in 
units of 8pi (so the values are just 1/8pi). But if you run a GW 
calculation (see example3), the code will produce the file 
epsilon.static which is the static dielectric tensor (in units of 8pi) 
of your material.

For parallel cal moh! never found such problems even going to 
216kpoints. Maybe is a memory problem.

bests

Layla

Quoting sudhir kumar <drsudhirkumar_in at yahoo.com>:

> Dear Users,
> quaries are related to the sax ver 1.0.1
> 1. Could you pl. tell me about static.epsilion file in eaxmple2.
>     whether it related  to the system or it independent to the sstem.
> 2. parallel processing of gw.x , bse.x and spectra.x could  not not 
> work after 80 k points.
>    on the other hand , it runs in serial  for dense k kmesh.
> sudhir
>
>
>
>
>
>
> _______________________________________________
> Sax-project-users mailing list
> Sax-project-users at qe-forge.org
> http://qe-forge.org/mailman/listinfo/sax-project-users
>



----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.